SMR Gearbox Installation
Satisfactory effectiveness is dependent upon right set up. lubrication and servicing. hence it is vital that the directions in the installation and upkeep leaflet. provided with every single gearbox. are followed thoroughly. a number of the important elements of belt and torque-arm installation are listed under.
one. Install pulley on gearbox input shaft as shut to the reducer attainable, and mount reducer on driven shaft as shut to bearing as useful. failure to complete this can bring about extra loads within the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive using the belt pull at about 90° for the center line involving driven and input shafts. this may allow tensioning of the wedge belt drive with all the torque arm which really should ideally be in tension. if output hub runs anti-clockwise. torque arm need to be positioned the correct.
three. lnstall torque-arm fulcrum on a rigid support so that the torque-arm will probably be at about ideal angles towards the center line through the driven shaft and also the torque arm situation bolt. be sure there is sufficient get up within the turnbuckle for belt tension adjustment.
Hold close.
Bell drive may very well be located in any convenient postion. if the torque arm is to be utilised to tighten the belts, the drive really should be at 
about tight angle to your line among the input and output shafts.
Bell drive can be positioned to the right if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite path to that proven while in the illustration.
Torque arm and belt take up.
Torque arm may very well be mounted to your proper if sought after.
