Electrical power UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is built exclusively to the smaller lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit has been broadly utilized within the field of logistic units such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled by the solenoid valve together with the velocity managed from the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This power unit is created exclusively to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve plus the speed controlled from the adjustable needle valve. When the lift rises to a higher positoin, but the energy provide is minimize, the decreasing movement is controlled from the manual override perform.
Power UNITS FOR LIFT TABLE three
General Description
This power unit is made solely to the big lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as velocity managed by a stress compensated flow handle valve.
Power UNITS FOR LIFT TABLE 4
General Description
This power unit is created exclusively to the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and the speed managed by the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power supply is lower, the decreasing movement is managed by the guide override perform.
Particular Notes
1. This power unit is of S3 duty cycle, which can only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all the hydraulic parts concerned ahead of set up of the electrical power unit.
three. Viscosity from the oil shoud be 15~46 cst,which really should also be clean and absolutely free of impurities.N46 hydraulic oil is proposed.
4. Oil transforming is needed just after the initial one hundred 
operation hrs,afterwards the moment every single 3000 hours.
5. The energy unit shown is created to be mounted vertically.
