C and CFR Style Effectiveness Data

C Sort Flex-Flex Couplings
The C Kind coupling includes two flex hubs, one sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Variety Flex-Rigid Couplings
The CFR Sort coupling consist of a single flex hub, 1 rigid hub, 1 sleeve, a single accessory kit consisting of seals and snap rings.
Capabilities
Straightforward and low-cost type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Obtainable as vertical and horizontal couplings
Broad variety of particular variations which include full-flex, flex-rigid mill motor
Regular configurations are available of the shelf
Ordering Data
Application: Driver and Driven.
Sort and size of coupling, horizontal, vertical etc.
Energy: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Information and facts
Puller Holes are conventional on sizes 4 via 12.
Puller Holes can be found for sizes 7/8 as a result of 3.5 at an additional charge.
The BSE (distance Involving Shaft Ends) may differ involving G and G1.
Interference bores with no set screws are standard except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Area.
Greater sizes can be found, please check with Technical Assistance.